Re: Pulling Left
Posted: 01 Mar 2017 05:35
What tyres are you running with?
Stefan my tyres are to heavy !! I run without tyres but I need to upgrade my tekkies they are getting moeg
Shalom
Nissan Patrol 4x4 (Africa)
Welcome Patrollers and Friends! A resource for Nissan Patrol enthusiasts in Africa - LAUNCHED April 2009.
https://www.patrol4x4.co.za/
Pulling Left
Page 2 of 2
Re: Pulling Left
Posted: 01 Mar 2017 08:25
Re: Pulling Left
Posted: 01 Mar 2017 10:46
Not sure who you are directing the question at, but I am running 33x12.5x15 HT's on 15x8J -40 offset rims at around 2bar pressure as anything above that causes the tyre to stand with a bulge in the center of the tread.Stefan wrote:What tyres are you running with?
Re: Pulling Left
Posted: 01 Mar 2017 21:18
Think he is asking DaleB....(?)davidvdm wrote:Not sure who you are directing the question at, but I am running 33x12.5x15 HT's on 15x8J -40 offset rims at around 2bar pressure as anything above that causes the tyre to stand with a bulge in the center of the tread.Stefan wrote:What tyres are you running with?
I have before heard of issues with certain brands of tyres pulling to one side...
Re: Pulling Left
Posted: 03 Mar 2017 12:11
I con my Sani into running more "true" by running 2.2bar on the left front and 1.9bar on the right 
Re: Pulling Left
Posted: 05 Mar 2017 07:39
Im running with Maxxis Muds 285/75/17. Been doing this since new. run 2 bar pressures front and back pretty much all the time unless I am doing a long "high speed" tar run loaded.
What I was considering is to machine a spacer for the left radius arm to push it forward about 5-10mm. on the last wheel alignment printout I had the diffs where not quite parallel but were well within spec. Lost the printout... can't remember by how much.
The suspension change made this much worse but I did the tires on the same day...?
What I was considering is to machine a spacer for the left radius arm to push it forward about 5-10mm. on the last wheel alignment printout I had the diffs where not quite parallel but were well within spec. Lost the printout... can't remember by how much.
The suspension change made this much worse but I did the tires on the same day...?
Re: Pulling Left
Posted: 05 Mar 2017 17:11
Ah, muddies...
Just rotate the tires left to right and see if it makes any difference?
Just rotate the tires left to right and see if it makes any difference?
Re: Pulling Left
Posted: 06 Mar 2017 11:51
Dale, I have thought about this as well. I dont see any problem in doing this. It has to workDaleB wrote:What I was considering is to machine a spacer for the left radius arm to push it forward about 5-10mm.
Re: Pulling Left
Posted: 06 Mar 2017 21:56
Hi Peter, tried that a few times, well actually tried a few different rotation patterns. I got no joy.Peter Connan wrote:Ah, muddies...
Just rotate the tires left to right and see if it makes any difference?
I think I will redo alignment and get some spacers machined, will do at my next rotation... always a waste of time sitting there for hours...