Nissan Patrol 4x4 (Africa)

List:-

1 ) Greg (Juice)
2 ) Dirk ( Off Road Biker )
3 ) Phillip (SCUBA Patrol)
4 ) JP (hugejp)
5 )Andre {Leeuloop ]
6 ) Henning (Picasso)
7 )
8 )
9 )
10)

List:-

1 ) Greg (Juice)
2 ) Dirk (Off Road Biker)
3 ) Phillip (SCUBA Patrol)
4 ) JP (hugejp)
5 ) Andre (Leeuloop)
6 ) Henning (Picasso)
7 ) Stefan
8 )
9 )
10)

1 ) Greg (Juice)
2 ) Dirk (Off Road Biker)
3 ) Phillip (SCUBA Patrol)
4 ) JP (hugejp)
5 ) Andre (Leeuloop)
6 ) Henning (Picasso)
7 ) Stefan
8 )Andries
9 )
10)

Tx Cedric - I needs these before I can sell the SGL

AndriesS wrote:One last check Are they just cut from 6mm plate or machined on the sides?

Previous post was tongue in cheek.

Its lazer cut from a 6mm plate. If one goes any thicker the stud thread protrusion I feel becomes less. On 6mm there is still more than enough meat left on the studs to ensure a good tight fit.

Cedric,
Have I missed the planned cost of a set of spacers or will this be determined by the QTY?
Thx.
Riaan

It works out to R 61.00 each.... ( not sure why 61 and not 60.....hahahaha ), so for a set of 4 it works out to R 244.00 irrespective of quantity, but it would just be easier to make a batch of them instead of 1 at a time, and this also saves labour time!!

Is there anyone else looking for a set of these? It would be good to get 10 sets made up in one go.

1 ) Greg (Juice)
2 ) Dirk (Off Road Biker)
3 ) Phillip (SCUBA Patrol)
4 ) JP (hugejp)
5 ) Andre (Leeuloop)
6 ) Henning (Picasso)
7 ) Stefan
8 ) Andries
9 )
10)

Ok ok ,I will take a set

haha.... aggg ok then....

1 ) Greg (Juice)
2 ) Dirk (Off Road Biker)
3 ) Phillip (SCUBA Patrol)
4 ) JP (hugejp)
5 ) Andre (Leeuloop)
6 ) Henning (Picasso)
7 ) Stefan
8 ) Andries
9 ) Wilkie
10)