Page 2 of 5
Re: Front wheel brearing spanner
Posted: 13 Apr 2012 08:29
by Peter Connan
Hello guys.
This is what I have ended up with:
- NPHS.jpg (206.82 KiB) Viewed 1752 times
At R100-R150 each, who is interested?
Re: Front wheel brearing spanner
Posted: 13 Apr 2012 08:31
by Grant
One for me
Re: Front wheel brearing spanner
Posted: 13 Apr 2012 09:24
by SCUBA Patrol
Peter,
I'm placing my order, need it to replace some wheelstuds!
Re: Front wheel brearing spanner
Posted: 13 Apr 2012 10:25
by David
Ek is in...
Re: Front wheel brearing spanner
Posted: 13 Apr 2012 10:58
by AndriesS
Add my ook., gaan hy n 1/2 drive vat?
Re: Front wheel brearing spanner
Posted: 13 Apr 2012 11:56
by SCUBA Patrol
Hy beter 1/2 drive vat ek het nie grooter nie!
Re: Front wheel brearing spanner
Posted: 13 Apr 2012 13:51
by Peter Connan
SCUBA Patrol wrote:Hy beter 1/2 drive vat ek het nie grooter nie!
Yes, it's 1/2" drive. Ons het hier by die werk 'n 3/4" torque wrench was tot 1000Nm gaan. En 'n 1" hidrolise een wat tot omtrent 10 000 Nm gaan...
Re: Front wheel brearing spanner
Posted: 13 Apr 2012 15:51
by ricster
I'll take one too Peter !!
Re: Front wheel brearing spanner
Posted: 17 Apr 2012 08:13
by ricster
Peter.... When do you think these will be ready..... I ask as my front wheels seem to have a little too much play for my liking when I took the front wheels off to clean and check brake pads. This could also be a factor in my slight wheel wobble when driving
Re: Front wheel brearing spanner
Posted: 17 Apr 2012 09:06
by Peter Connan
Cedric, it's going to take me at least two-three weeks.
I would recommend you do a temporary fix using some drift punches (put two in opposing holes, and turn with a screwdriver between them), you shouldn't need much torque as you are not seating the bearings.