Hizit boys,
So after 5 years of Zero Issues with my Patrol my left indicator started flicking double time yesterday.... I thought it was just a globe but then all of a sudden its back to normal,...and this keeps happening.
Any ideas?
Indicator issues.... Please shed some light
- Russ Kellermann
- Patrolman 1000+
- Posts: 1148
- Joined: 01 Feb 2010 22:39
- Full Name: Russell Kellermann
- Nickname: Russell Kellermann
- Home Town: Cape Town now, grew up on the Wild Coast.
- Current 4x4: 2007 Patrol 4.2D Pickup
2005 Patrol 4.2TD Wagon - Home Language: English
- Has thanked: 8 times
- Been thanked: 93 times
Indicator issues.... Please shed some light
'07 Patrol Pickup TD42 N/A,285's KM2,3" Lift,ONCA Bars,Warn High Mount,Alu Canopy, and some other Stuff.
- ricster
- Patrolman 1000+
- Posts: 5850
- Joined: 13 Jan 2010 11:16
- Full Name: Cedric Warner
- Nickname: Cedric
- Home Town: Alberton Gauteng
- Current 4x4: '99 Nissan Patrol 4.2 Turbo Diesel
- Home Language: English
- Location: LA..... No not Los Angles ..... Lower Alberton, Gauteng
- Has thanked: 591 times
- Been thanked: 468 times
Re: Indicator issues.... Please shed some light
Russ, after a few years and especially being near the coast, it is probably the globe holder that has corroded slightly over the years. On my rear tail lights, the ones in the plastic at the bottom, the metal has corroded to the point of it being very difficult to get the globe out without a little vigorous wiggling and Q20.
I cleaned the holders wit a little fine sand paper to ensure a good contact between the globe and the holder and a thin film of Q20 to help prevent further corrosion. I think too much Q20 or similar will cause a short, so I used an earbud and just wiped a layer on.
I'm not sure how the rear tail lights look on the pick up, but assume that they are similar to the station wagons. The spray from under the vehicle when driving on a rainy road can seep into any nook and cranny.... So start at the first one and work your way around them all.
Let us know how it goes
I cleaned the holders wit a little fine sand paper to ensure a good contact between the globe and the holder and a thin film of Q20 to help prevent further corrosion. I think too much Q20 or similar will cause a short, so I used an earbud and just wiped a layer on.
I'm not sure how the rear tail lights look on the pick up, but assume that they are similar to the station wagons. The spray from under the vehicle when driving on a rainy road can seep into any nook and cranny.... So start at the first one and work your way around them all.
Let us know how it goes
Regards
Cedric
Nissan Patrol GL 4.2 Diesel Turbo (Iron Maiden)
Nissan SANI 3.0 V6 4x4 (SOLD)
Isuzu KB 280 DT 2x4 ('ol Smokey) - SOLD
Suzuki TL 1000R "V twin" (Growler) - SOLD
Cedric
Nissan Patrol GL 4.2 Diesel Turbo (Iron Maiden)
Nissan SANI 3.0 V6 4x4 (SOLD)
Isuzu KB 280 DT 2x4 ('ol Smokey) - SOLD
Suzuki TL 1000R "V twin" (Growler) - SOLD
- SCUBA Patrol
- Senior Member
- Posts: 412
- Joined: 08 Apr 2009 11:15
- Full Name: Phillip Jacobs
- Nickname: Phillip
- Home Town: Cape Town (Stellenbosch)
- Current 4x4: Patrol 2006 3l diesel(die eerste Voetspore een)
- Home Language: Afrikaans
- Location: Cape Town, Stellenbosch (Paradyskloof)
- Has thanked: 31 times
- Been thanked: 32 times
Re: Indicator issues.... Please shed some light
Russ, I agree with Rick, check all the connections, remove each bulb check the holder and the bulb, spray with switch cleaner then replace and test. A good idea is to change all the bulbs as the solder have corroded to an point where the bulb is still fine but the connection points bad. After testing spray with Q20 as it is a water repellent. It should not cause a short but it will inhibit the corrosion effect.
Phillip
2006 3l with MADMAN
2006 3l with MADMAN
- Russ Kellermann
- Patrolman 1000+
- Posts: 1148
- Joined: 01 Feb 2010 22:39
- Full Name: Russell Kellermann
- Nickname: Russell Kellermann
- Home Town: Cape Town now, grew up on the Wild Coast.
- Current 4x4: 2007 Patrol 4.2D Pickup
2005 Patrol 4.2TD Wagon - Home Language: English
- Has thanked: 8 times
- Been thanked: 93 times
Re: Indicator issues.... Please shed some light
Thanks guys,... seems to be a connection thing rather than a globe thing cause i made sure connections were all tight and secure, seems to have disappeared, however, i am going to disconnect all of them, spray, replace globes, and refit with spray,and should be good for another 7 years or more.
'07 Patrol Pickup TD42 N/A,285's KM2,3" Lift,ONCA Bars,Warn High Mount,Alu Canopy, and some other Stuff.
- ricster
- Patrolman 1000+
- Posts: 5850
- Joined: 13 Jan 2010 11:16
- Full Name: Cedric Warner
- Nickname: Cedric
- Home Town: Alberton Gauteng
- Current 4x4: '99 Nissan Patrol 4.2 Turbo Diesel
- Home Language: English
- Location: LA..... No not Los Angles ..... Lower Alberton, Gauteng
- Has thanked: 591 times
- Been thanked: 468 times
Re: Indicator issues.... Please shed some light
Yip ....That's the Patrol way brother
Regards
Cedric
Nissan Patrol GL 4.2 Diesel Turbo (Iron Maiden)
Nissan SANI 3.0 V6 4x4 (SOLD)
Isuzu KB 280 DT 2x4 ('ol Smokey) - SOLD
Suzuki TL 1000R "V twin" (Growler) - SOLD
Cedric
Nissan Patrol GL 4.2 Diesel Turbo (Iron Maiden)
Nissan SANI 3.0 V6 4x4 (SOLD)
Isuzu KB 280 DT 2x4 ('ol Smokey) - SOLD
Suzuki TL 1000R "V twin" (Growler) - SOLD
- Tinus lotz
- Moderator
- Posts: 7579
- Joined: 29 Aug 2010 13:07
- Full Name: Tinus lotz
- Nickname: Tinus lotz
- Home Town: Centurion
- Current 4x4: Nissan patrol 4.8 GRX 2005
Toyota 2.7 legend 35 LWB 4X4 - Home Language: Afrikaans
- Has thanked: 800 times
- Been thanked: 549 times
Re: Indicator issues.... Please shed some light
Russ
I would start to strip open the covers then shake the globe holders globe etc....once you lose connection the resistance will change and the flicker will work double time .....some older models cant work on led globes ....just get the problem first and then fix and maintain it then .....had a problem similar on my hilux and it was the wire that had broken off internally just before it meets the globe holder ....it can be like mine because the wire wasn't supported when front steel bumper was fitted....just my
I would start to strip open the covers then shake the globe holders globe etc....once you lose connection the resistance will change and the flicker will work double time .....some older models cant work on led globes ....just get the problem first and then fix and maintain it then .....had a problem similar on my hilux and it was the wire that had broken off internally just before it meets the globe holder ....it can be like mine because the wire wasn't supported when front steel bumper was fitted....just my
Who is online
Users browsing this forum: No registered users and 11 guests